January 30, 2017

1982 E28 S54 Project

A project we have been working on has finally come to a close. Beautiful 1982 E28 525 Euro spec car was shipped over and we went to work. Fully rebuilt S54 and 6 speed transmission installed and all custom harness, lines, mounts, and installation performed here at Flying Wrench. More pics to come in the future as we get them loaded.

 

January 30, 2017

Porsche 911 Project (997 C2)

911 Project 

Coming in for some maintenance, And this 911 needed it. List as follows 

-IMS Bearing, Clutch, Flywheel, Shifter cables,  Front and rear Brake pads, Rotors, and sensors, New steering rack, Water pump, Power steering tank, Bilstein B16 Coilover kit, New Upper and lower control arms, Wheels and Tires, New FABSPEED Exhaust complete with Headers, FABSPEED Intake system, GT3 Throttle body and IPD Plenum. New Belts and hoses, And an nice Turbo Deck lid to finish it all off. 

Full write up to come soon. 

 

November 10, 2014

New Project M3

Although we don't have a project name yet, Here's the newest member to the flyin wrench family.

 

 

November 08, 2014

From the beginning.

The story behind the name is really pretty simple, embarrassing but simple.

 

It was about 15 years or so ago, my friend  and I were working on his car. We were at this little crap hole shop he worked at, it was cold as hell and we had no heat in the shop.  We may have been drinking,  a lot. But that’s not what’s important here.  This place was an old run down shop that had been many things in the past but now it’s an old German automotive repair shop. In the back of this shop sits a 50's Mercedes, this thing had been there for years. It really wasn't much to look at and I really had no idea what what is was at the time... Or what the next 15 minutes held for us but we were on this path already and we weren't turning back.  We were killing ourselves to remove this one bolt under the intake of the car and it wasn't coming off without a fight!  It's the middle of the night in this dungeon and we are about two hours into this bolt debacle. Needless to say tempers were flaring.  Then it happened, we were having a conversation about starting our own company because of the crappy work conditions and the wrench he was working with slipped for the thousandth time and he smashed his hand AGAIN!!  The next thing I know he turns and throw’s this wrench as hard as he could.  This had been the summary of the night.  I had retrieved just about every tool we had from the other end of the shop for one reason or another but this time… this time it happened!!! We hear a loud thud and I see this look of horror on my friends face. We both walk to the end of the shop to retrieve the wrench but this time it hit something else, it hit the fender of what I would find out later is a $500K 50's Mercedes sitting quietly in the back of the shop! Thus Flyin Wrench was born!  The rest is a blur of drunken rage and damaged vintage car parts. This was just one of a thousand stories we will tell over the years when we sit and remember all that we have went through together!

 

M

November 05, 2014

Opening Day!

Today we officially launch the new Flyin Wrench website! Its been a long road to get here. theres a whole story behind the name, and a little more about ourselves coming in the future. Hope our loyal customers like it here. We have a lot in store for this site, and our company. 

 

So Welcome to flyinwrench.com!

 

M